Skip to content

Reading Boomwhacker Music: How Students Play from Color-Coded Notes

Boomwhacker music shows each note in the color of its tube. At first, students read only the color: when it’s their color’s turn, they play. To turn this into real note reading, the colored note heads should sit on a staff, and the colors should fade out over time.

Robert Koegler, music teacher · Last updated:

Three kinds of Boomwhacker music

“Boomwhacker music” covers very different kinds of sheets. They differ in how much students can actually read from them.

KindWhat it looks likeWhat students read from itLimits
Colored dots in a rowColored circles or boxes side by side, no staff lineswhich color comes nextNo rhythm, or only a rough idea of it. Doesn’t lead to standard notation.
Color-coded notes on a staffNote heads in tube colors on five lines, with stems and flags, often with a letter insidepitch, duration, measures and restsNeeds a short introduction to note values.
Play-alongColors travel along lanes to a line and light up when it’s time to playwhen it’s their color’s turnPractices reacting and playing together, not reading.

All three have their place. Colored dots work for a first song in the first few minutes. The play-along carries a whole class through a piece, even when nobody reads music yet. But if students are going to learn to read, they need the staff.

What colors show and what they don’t

The color only tells you which note to play. It doesn’t tell you how long it lasts. That’s what note values are for: a quarter note lasts one beat, a half note two beats. A row of colored dots loses this information. Students then play every note the same length, and the song sounds strange.

The color also doesn’t tell you whether a note is high or low. On the staff, that’s shown by where the note sits on the lines. A colored note head combines both: the color helps students find the tube, the position on the staff shows the pitch, and the stem and flag show the duration.

So color-coded notes can either prepare students for reading music or replace it. If the colors stay forever, students only look at the color and never at the lines. That’s why I fade out the colors in set stages.

How students read a color-coded score

When a class gets a sheet with color-coded notes on a staff for the first time, this is what I do:

  1. Find your color: Each student runs a finger along the line and counts how often their color appears.
  2. Listen and follow along: The song plays once while students follow with a finger. When they reach their color, they tap the sheet.
  3. Clap the note values: The class claps the rhythm of the first line and says the rhythm syllables along with it (ta for a quarter note, ti-ti for two eighth notes, ta-a for a half note).
  4. Find the rests: Students point to the rest symbols. During a rest nothing sounds, but the beat keeps going.
  5. Play slowly: The class plays the song at a slow tempo, first line by line, then all the way through. Then the tempo goes up.

In group work, one student per group leads and counts off. You’ll find a full lesson plan with color-coded music and group work in the sample lesson.

From color to notation in four stages

On the Note Reading page, the colors disappear step by step. The melody stays the same; only the support gets smaller:

LevelNote headWhat the student has to do on their own
1colored, with note namesnothing but follow the color
2colored, without namesmatch the color to the tube
3just a colored outlinepay attention to the position on the staff, with color only as a check
4black notes onlyname the note from its position on the staff alone

There’s also a “Which note is this?” quiz with colored, color-outlined or black note heads. You can open it full screen on tablets with a QR code. The memory aids stay close to the tubes: the lines from the bottom are E, G, B, D, F, “Every Good Boy Does Fine”. The spaces spell the word FACE. And the higher the note sits, the shorter the tube.

How long a class stays at one stage depends on the class. I only move on when most students find their note at the current stage without hesitating. For note values, there’s the Note Value Builder, where you click rhythms together and listen to them.

Color blindness in your class

About 8 percent of boys and about 0.5 percent of girls of Northern European descent have red-green color blindness. So in a class with twelve boys, there’s often one student who has it. They mainly mix up red and green, which on Boomwhackers means C, F and G.

That’s why every colored note and every tube should also show the note name. It’s printed on Boomwhackers®, and on bimbadi you can turn on the labels everywhere. Many kids won’t tell you on their own that they mix up colors. If a student keeps coming in wrong at the same spot, it’s worth checking.

Where to get color-coded music

Many songs on bimbadi run as free play-alongs that light up each color right when it’s needed.

You can build your own short patterns on the interactive board. That’s not enough for a whole song, but it works for an ostinato or an accompaniment.

Frequently asked questions

What does the letter in the note head mean?

It’s the name of the note, for example C or G. It helps students who mix up colors and connects the color with the note name. In later stages, the letter goes away.

How does Boomwhacker music show rhythm?

Only color-coded notes on a staff show the rhythm, with note values like quarter, eighth and half notes. Rows of colored dots usually show only the order of the notes.

Do color-coded notes keep students from learning to read music?

That can happen if the colors never go away. If you fade them out in stages, they prepare students for reading music. On bimbadi.com, the Note Reading page goes in four stages from colored notes to black note heads.

Where can I find free Boomwhacker music?

On bimbadi.com, several songs run as play-alongs without a code, including Happy Birthday, Are You Sleeping (Frère Jacques), Morning Mood and Beethoven’s Fifth.

What about students who are color blind?

Always show the note name on the tube and the note as well. Color-blind students mainly mix up red and green, which on Boomwhackers means C, F and G. With the name, every student can play along.

Keep reading

How do you take your classes from the color code to standard notation? Write to me through the feedback form.

Robert